AT-131002 / BOSCH LSU4.9 WIRE HARNESS ONLY 1.2M (4 FT)

The Wideband Hardware Pack contains a pre-terminated 1.2m flying lead harness with a Bosch style 6 pin LSU 4.9 connector on one end. This harness must be installed correctly.

WARNING: Incorrect installation of this Wideband Hardware Pack will damage your ECU.

Follow the steps below and outlined in Modular ECU Board Product Insert document, coupled with the wiring guide located in the Eugene Software to correctly install your Wideband Harness.

Note: This harness is pre-terminated with pins for use with an AMP Superseal connector. If a modular plug-in ECU is being used, the pre-terminated pins must be cut off and the harness must be terminated using the OEM ECU pins.